diff -r 328f2d956cbe -r c4cdf14b6868 core/com.nokia.carbide.cpp.doc.user/html/tasks/debugger/run_mode_debug_01.htm --- a/core/com.nokia.carbide.cpp.doc.user/html/tasks/debugger/run_mode_debug_01.htm Tue Mar 09 10:34:04 2010 -0600 +++ b/core/com.nokia.carbide.cpp.doc.user/html/tasks/debugger/run_mode_debug_01.htm Tue Mar 09 17:31:44 2010 -0600 @@ -1,37 +1,30 @@ - - - - - - -Debugger Settings - - - -

Run Mode On-Device Debugging

-

To implement run mode on-device debugging the following tasks need to be completed.

-
    -
  1. Install device connection software
    2. -
  2. Install Perl
    3. -
  3. Install an SDK
    4. -
  4. Setup environment variables
    5. -
  5. Setup a virtual drive for Techview and Cust Kits
    6. -
  6. Set the default kit in Devices.xml
    7. -
  7. Install the SISX file on the target device
    8. -
  8. Configure TRK connection on the device
    9. -
  9. Create a launch configuration
    10. -
-
-

Install PERL

- -
-

Software can be downloaded from: http://www.activestate.com/Products/ActivePerl/.

-

NOTE Later releases of Perl are not yet supported by the Symbian utilities and can cause unknown compiling errors.

-
-
- - - - + + + + + + +Installing PERL + + + +

Installing PERL

+

PERL is required for many Symbian OS utilities and commands.

+
+

Installing PERL

+ +
+

Software can be downloaded from: http://www.activestate.com/Products/ActivePerl/.

+

NOTE Later releases of Perl are not yet supported by the Symbian utilities and can cause unknown compiling errors.

+
+
+
Other references
+ + + + +