Gets API version number. Compare this to KTvOutConfigVersion, must match.

Listener for SetAvailableTvConfigList() Check always aListenerRequest.Int(), it is KErrNone when normal operation.

Cancels listener, AvailableTvConfigListListener

Enables/disables HDCP/Macrovision on Tv-output. All clients of CTvOutConfig has to disable protection, before protection on output can be disabled. CopyProtectionStatus() will be completed when protection state is changed (not necessarily ever).

ETrue = When client wants to enable protection. Protection is enabled after CopyProtectionStatus() returns ETrue (after listener). If sink does not support e.g. the HDCP, adaptation will try to enable that periodically and will trigger the listener when success and state changes.

EFalse = When client wants to disable protection. If any other CTvOutConfig's client is not called this method with ETrue, output will be unprotected after CopyProtectionStatusListener(). When HDCP is dropped out (CopyProtectionStatusListener()), this method should be called with EFalse (before next try with ETrue), that tells for adaptation that buffer content can be shown on Tv without protection.

Cancels listener, CopyProtectionStatusListener

Listener for status of copy protection (e.g. HDCP). After this, check newest status with CopyProtectionStatus() HDCP may drop off with CopyProtection(EFalse) or when authentication is failed. CopyProtectionStatus()

Asks is TV-out enabled or not

Get list of available Tv-configurations

Use CTvOutConfig::OnOffListener method, when Tv is enabled, then new settings can be read using this method.

If this read fails, try also read overloaded version for THdmiDviTimings reading, and vice versa. Latest set version of GetConfig can only return without error, that is the version what is currently used in HW (TTvSettings/THdmiDviTimings)

GetConfig(TTvSettings& aTvSettings)

Reads number of supported modes what to be called with GetSupportedHdmiMode. GetSupportedHdmiMode

Reads supported modes of HDMI hardware GetNumberOfHdmiModes

Reads capabilities of own HDMI hardware.

Asks is HDMI-cable connected or not

Adds listener for HDMI connected/disconnected situations. Check always aListenerRequest.Int(), it is KErrNone when normal operation.

Cancels listener, HdmiCableListener

Creates object. Method requires ECapabilityReadDeviceData capability. TvOutConfig.h TvOutConfig.h

Adds listener for tv-out enable/disable situations. Check always aListenerRequest.Int(), it is KErrNone when normal operation.

Cancels listener, OnOffListener

Set list of available Tv-configurations

Before Tv-out using, SetConfig must be called (during boot and always when settings or connector are changed). Fill correct values to TTvSettings object and give it by parameter.

Some settings can be changed on the fly (while tv-out enabled, some settings will be in use only after Tv-out Disable()/Enable() sequency. For example, if e.g. overscan is changed on the fly, client gives same early filled struct but only overscan members are different. KErrNone will be returned if change was success, if HW cannot change settings on the fly (without Disable()/Enable()) then KErrNotReady is returned. When KErrNotReady is returned, settings are needed to write with KErrNone after Disable() and before Enable()

If this is called, THdmiDviTimings will not be used anymore and vice versa.

Sets HDMI settings to Hw SetConfig(const TTvSettings& aTvSettings)

Adds listener for changed settings Check always aListenerRequest.Int(), it is KErrNone when normal operation.

Cancels listener, SettingsChangedListener

Returns maximum size of TStandByFigure.iTable in bytes. Deprecated since TB10.2.