Collapse all Symbian^3 Product Developer Library

Connecting and Disconnecting a Remote Host Tutorial

This topic describes how to connect and disconnect a remote host.

Introduction

To send and receive the data packets, a connection must be established with a remote host. This tutorial describes the following:

How to Connect to a Remote Host

The high level steps to connect to a remote host are as follows:

The RSocket::Connect() function connects to a remote host. The RSocket::Connect() parameters identifies the required type of socket connection. For more information, see important parameters .

For TCP sockets
1. An active connection is made to the remote host. When the socket call completes successfully, the socket can send and receive data. To create a connection, the protocol must establish a network interface and a route to the destination. For more information about this process and return values, see the RSocket::Connect() function.
For UDP
1. UDP is a connectionless protocol which means the RSocket::Connect() does not have to be called before writing data with RSocket::SendTo(). It can be used to set the address for all data sent from the socket. In this case, Send()/Write() function can be used in addition to SendTo() function.

For cancelling the connection

The RSocket::CancelConnect() function cancels the outstanding connect operation with a remote host. This function also cancels any outstanding RSocket::Ioctl() calls. After this call, a socket can be reconnected by RSocket::Connect() function.

A TCP socket can be set to listen with RSocket::Listen(). The aDataOut argument is ignored.

A connection request to a listening socket can be accepted with RSocket::Accept(). An aConnectData argument cannot be specified.

Use RSocket::Shutdown() to asynchronously shut down a TCP. Disconnection data is not supported.

The following table describes the effects of different types of shut down for TCP:

Type	Action
`ENormal`	Blocked reads and writes are terminated. No further data is accepted from the remote source and TCP disconnect is initiated.
`EStopInput`	Blocked reads are terminated. No further data is accepted from the remote source.
`EStopOutput`	Blocked writes are terminated. TCP disconnect is initiated.
`Eimmediate`	Blocked reads and writes are terminated. The connection is terminated by sending a reset.

Parent topic: Tutorials